Revo nonsliding knot. Place knot pusher on post strand. A, Throw underhand loop (first half-hitch) around post, and advance loop into operative cavity, alternating tension on each strand until first half-hitch is tightened down on tissue to be opposed. B, Withdraw knot pusher while maintaining tension on post strand, and throw another underhand half-hitch around same post. Push it into joint until knot has seated. C, Maintain tension on post strand, and this time overhand throw around same post and push down into place. Tension knot by past-pointing, accomplished by passing knot pusher beyond knot sequence and applying tension on both strands while holding pusher in position beyond knot. Knot pusher is switched to second limb, which is designated as new post. D, Throw an underhand half-hitch around new post and tension. E, Switch knot pusher to original post, and throw an overhand hitch and tension. F, Alternatively, pull half-hitches into joint by placing knot pusher on loop strand ahead of loop and drag loop into position. Tighten knot by past-pointing on each loop. Cut tails of suture 3 to 4 mm from knot.